Knowledgebase
Online Technical Support
Software Upgrades: Please check our latest Download section.
Search Tip: You can increase the accuracy of your searches by using as many keywords as possible. Remove any common words such as "a", "or", "the" as they will be used in the search. Do not use any operands such as +, or quotation marks to enclose phrases.
|
Our FAQ
# |
Title |
1 |
|
2 |
How do I overcome the use of more than one port of the AT-FAST at a time How do I overcome the use of more than one port of the AT-FAST at a time on a Microsoft Windows NT operating system. For example I cannot run TERMINAL.EXE more than one time and if I try to open more than one port with this application, I get an error message saying: "Error IRQ Busy". The driver version I am using is 1.0. |
3 |
NT starts up with the old settings and my card does not function I am using the AT-FAST card to dial up to our WinNT 4.0 or 3.51 server. The card is currently set to IRQ 10 and Memory Base Address 100. If I then change these settings, shut down my machine and change the jumper settings on the card, NT starts up with the old settings and my card does not function, why? |
4 |
Ports are not shown I have installed an AT-FAST into the system and in control panel you can view the COM ports, but when loading a terminal emulation package or trying to add a modem the ports are not shown. How can I resolve this problem? |
5 |
When our users dialled-in the modems refused to answer After installing the Service Pack the modems connected to the AT-FAST 8 port stopped working. When our users dialled-in the modems refused to answer; even the ring-LED on the modems didn't flash anymore? |
6 |
Refreshing the screen would hang until a ^Q was issued I am having problems with screen drawing using AT-FAST under SCO UNIX and driver version 1.0. Refreshing the screen would hang until a ^Q was issued? |
7 |
Card runs very slowly and seems to run in bursts After installation of the AT-FAST, under SCO UNIX, the card runs very slowly and seems to run in bursts? |
8 |
What selection should I use and what is AT-FAST5? I am running Mkdev serial using driver version 1.x and the following is shown: AT-FAST I/O 100 AT-FAST5 I/O 180 What selection should I use and what is AT-FAST5? |
9 |
Can you use the AT/PCI-FAST driver version 2.0 in a SCO 3.2.4.2 system? Can you use the AT/PCI-FAST driver version 2.0 in a SCO 3.2.4.2 system? If you can, how can it be done? |
10 |
How do I change the COM port from 5 to the next available? How do I change the COM port from 5 to the next available, for the AT-Fast card. |
11 |
|
12 |
PCI-FAST and Linux fax issues. The serial port displays scattered text ? |
13 |
|
14 |
|
15 |
IOLAN+ and FAST4 cables UltraPort serial card cable compatibility with the IOLAN+ RJ45 and FAST4 RJ45 ports. |