Knowledgebase
Online Technical Support
Software Upgrades: Please check our latest Download section.
Search Tip: You can increase the accuracy of your searches by using as many keywords as possible. Remove any common words such as "a", "or", "the" as they will be used in the search. Do not use any operands such as +, or quotation marks to enclose phrases.
|
Issue:
How to globally disable RIP on the Jetstream and CS9000.
Note: the Ethernet, PPP, and SLIP interfaces will all be affected.
Solution:
Jetstream
To disable the route daemon (RIP) you must use the OEM Mode of 4.
Add 004 (hex) to the current OEM Mode configured in the Server Configuration.
Example: current OEM mode = 002 (hex)
002 + 004 = 006 (hex)
Save and Reboot
CS9000
To disable the route daemon you must remove it from the Services configured in the Server Configuration.
Subtract 0002 (hex) from the current Services value.
Example: current Services value = fffe (hex)
fffe - 0002 = fffc (hex)
If you run the "show server" command you will see the services that are enabled ... example:
services fffc
(SPCD+SNMPD+HTTPD+SSHD+TELNETD)
Then you can Save and Reboot.
Note: on older firmware versions of the CS9000 the Services is not available. In this case you must follow the instructions for the Jetstream (above).
Related
Articles:
1.) Route daemon cannot be disabled using the OEM mode.
Article ID: 460
Published: 1/14/2004 11:14:21 AM
Last Modified: 3/4/2004 1:37:04 PM
Issue Type: Configuration
We can provide more information about our products or arrange for a price quotation.
Send an Email
Call Us