Quickset fails when configuring the IOPRINT+

Issue:
It fails when using QUICKSET to configure IOPRINT+ as Print Server or Remote Printer in Netware 3.x and Netware 4.x?

Solution:
STEP 1: Check Both LED status
Green LED Red LED Status
Off Off No power to the print server
On On Hardware error or connection with file server is broken
On Off The IOPRINT is working normally
Flashing On or Off The print server is transmitting to or receiving packets from the network

STEP 2: Check Network Cable

(2.1) Make sure the Network Cable is work properly.

(2.2) Connect Network Cable before you power on IOPRINT.

(2.3) Connect ONE network cable at a time.

STEP 3: If the # of characters of your file server name is more than 20 char, please shorten it to less than 20, there is a limitation.

STEP 4: Please issue "set" command at console -> then choose "communication" -> then type " SET Reply To Get Nearest Server = on " at console.

STEP 5: Login on to the file server with supervisor rights

STEP 6: Using the QUICKSET.EXE in the IPX/SPX utility diskette that came with IOPRINT +.

STEP 7: If you still can not use QUICKSET.EXE to install --> Use PCONSOLE and PSCONFIG to configure the IOPRINT +


Article ID:
 169
Published:
 2/3/2003 12:17:27 PM
Last Modified:
 2/3/2003 12:17:27 PM
Issue Type:
 Trouble Shooting