Issue:
How much memory does a 594e require for multisession.
Cause:
A multisession configuration was created,but the multisession devices do not go active.
Solution:
The two tables below show the memory requirements for multisession devices. Note: A 594e base controller is configured with 8 megs of memory. Memory 72 pin non-parity 70 nano seconds,non EDO
NWS Display Type |
Installed memory 594e |
|
8 |
12 |
16 |
20 |
32 |
SBCS |
10 |
100 |
200 |
300 |
600 |
DBCS |
0 |
0 |
40 |
80 |
200 | (fig.1) 594e Base Controller.
Note: A 594e IP routing controller is configured with 16 megs of memory.
NWS Display Type |
Installed memory 594e |
|
16 |
20 |
32 |
SBCS |
10 |
100 |
400 |
DBCS |
0 |
0 |
120 | (Fig.2) 594e IP Routing or Network Controller.
NOTE:
Certain devices and hardware configurations can yield a greater number of sessions than listed in the tables above, for example, if all attached twinaxial devices are non-ECB and non-DBCS then up to 1000 NWS (Non programmable workstations) multi-sessions can be supported. The Perle 594e can be configured for up to a maximum of 40 controllers; these controllers can be emulated by actual feature.
Memory SIMM's must be configured in one of the following patterns:
Slot1 |
Slot2 |
Slot3 |
Total Memory |
4MB |
4MB |
4MB |
12MB |
4MB |
8MB |
|
12MB |
4MB |
16MB |
|
20MB |
8MB |
|
|
8MB |
8MB |
8MB |
|
16MB |
16MB |
|
|
16MB |
16MB |
16MB |
|
32MB |
Article
ID: |
17 |
Published: |
12/28/2002 10:01:37 PM |
Last
Modified: |
11/16/2004 8:19:59 AM |
Keywords: |
594,memory,multi |
Issue Type: |
Configuration |
|