Note: For this config example we are using Port 0 on the Model 3i. Attached to Port 0 is a modem using a straight-through cable. The DTE/DCE switch on Port 0 is set to the DTE position.

Select Port 0 and enter the following options:

Device Type: PTALKWIN
Changeable: *YES
Workstation Address: 0
Changeable: *YES
Session Type: Display
Baudrate: leave this field blank
Bits per character: 8
Parity: None
Stop bits: 1
Handshake method: RTS
Device Ready Method: DCDDSR

Configure the MODEL 3i Workstation Definition
Select workstation address 0 and change the Device emulation for 3180.  Leave all else at default settings.

Configuration is complete. Lastly, be sure to save the configuration (option 80 in main menu) and reboot the Model 3i.

=======================================================================================

Configure / ASCII Connection --> Model 3i / Click OK

Configure  / Session / Add / Device Type: Display / Session Name: Session A / Address: 0 / Click OK

Configure / Host Connection / Add / enter the "Host Name" ie, model3i / enter the "Phone Number" to dial  /
Click OK / Click the button "Set as Default Host" / Select "Connect to Default Host" / Click OK.

Configure / Communication settings / Port: specify the COM port that your PC modem is attached to / 
Baud Rate: specify the connection speed  / Handshake: Hardware / Click OK.

Configure / Modem Settings --> specify your modem type / Dialing option: specify Tone or Pulse / 
change the "Wait for connection" to 120 seconds / Click OK.

Configure / Mapping --> 5250

To connect to the Model 3i, select Session on the menu bar, following by Activate --> Session A.