Knowledgebase
Online Technical Support
Software Upgrades: Please check our latest Download section.
Search Tip: You can increase the accuracy of your searches by using as many keywords as possible. Remove any common words such as "a", "or", "the" as they will be used in the search. Do not use any operands such as +, or quotation marks to enclose phrases.
|
Issue:
How to configure PSeries router for Internet access over Frame-Relay.
Solution: By default the router will auto-learn the DLCI and LMI from your Frame-Relay network. Connect the router to the Frame-relay circuit and power on the router, then from the Main menu select the following menus and options. Configuration menu For the Template ID, enter the word 'none'. Connection Set-up menu
LAN setup menu
IP Set-up menu
IP Address [enter the private IP address and mask size for your router's LAN interface]
Press the = key.
Configuration menu
WAN Set-up menu
Link set-up menu
Link interface type [depending on your router model, specify the interface type being used]
Frame relay [enabled]
Press the TAB key.
Remote Site Set-up menu
Edit Remote site
For the Remote Site id enter the number '1' (assuming a Remote site was auto-created after auto-learning of the DLCI and LMI).
Primary link [depending on your router model, specify whether using link module in position 1 or 2]
PPP [Disabled]
State [enabled]
Press the TAB key.
Protocol Set-up menu
IP parameters menu
NAT [enabled]
Local IP Address [enter public IP address and mask size provided by your network]
Peer IP address [enter the ISP gateway IP address]
IP Routing menu
Routing protocol [none]
Auto default route [enabled]
Press the = key.
Save configuration
Diagnostics menu
Soft reset - yes to reset.